Page 1
CAL. VD75, VD76 ANALOGUE QUARTZ l T ime display: Hour and minute hands with small-second hand l C alendar display: Date and day of the week hands...
SCREW DOWN CROWN DISPLAY AND CROWN/BUTTONS [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. Locking the crown CROWN 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight. a: Normal position b: First click c: Second click...
TIME/CALENDAR SETTING DATE SETTING DAY AND TIME SETTING CROWN CROWN 1 Pull out to second click 1 Pull out to first click. when small-second hand 2 Turn clockwise to set Date is at the 12 o’clock posi- hand to the desired date. tion. 3 Push in. 2 Turn clockwise to advance Hour and Minute hands until Day hand is set to the desired day of the week.
When setting the time, check that AM/PM is set correctly. l When the battery expires, be sure to replace it as soon as possible to prevent any When setting the minute hand, advance it 4 to 5 minute ahead of the desired time malfunction. and then turn it back to the exact minute. l We recommend that you contact an AUTHORIZED PULSAR DEALER for battery replacement. The 24-hour hand (or 24-hour rotating wheel) turns full circle in one day. DATE SETTING Do not set the date between 10:00 p.m. and 2:00 a.m. Otherwise, it may not turn properly. While setting the date hand, check that it moves properly in one-day increments.
Page 5
(10 bar/15bar the watch becomes wet, we suggest that you CAUTION /20 bar)* have it checked by an AUTHORIZED PULSAR If “WATER RESISTANT 10 BAR”, DEALER or SERVICE CENTER. The battery is not rechargeable. Never attempt to recharge it, as this “WATER RESISTANT 15 BAR” or l Water resistance (3 bar) may cause battery leakage or damage to the battery.
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the CARE OF CASE AND BRACELET MAGNETISM crown is pushed in completely. Your watch will be ad- To prevent possible rusting of Do not operate the crown when the watch is wet or in water. If used in sea water, versely affected by strong rinse the watch in fresh water and dry it completely. the case and bracelet caused magnetism. Keep it away * When taking a shower with the water resistance 5 bar watch, or taking a bath with by dust, moisture and perspi- from close contact with ration, wipe them periodically the water resistance 10, 15 or 20 bar watch, be sure to observe the following: magnetic objects. • Do not operate the crown when the watch is wet with soapy water or shampoo. with a soft dry cloth. • If the watch is left in warm water, a slight time loss or gain may be caused. This PERIODIC CHECK SHOCKS & VIBRATION condition, however, will be corrected when the watch returns to normal tem- perature.
Need help?
Do you have a question about the VD75 and is the answer not in the manual?
Questions and answers