Connector
DC Power Connector: JPWR1
Th s connector s used to prov de power to the motherboard.
Fan Power Connector: SYSFAN1
The fan power connectors support system coolng fan wth +12V. When con-
nectng the wre to the connectors, always note that the red wre s the postve
and should be connected to the +12V; the black wre s Ground and should be
connected to GND. If the motherboard has a System Hardware Montor chpset
onboard, you must use a specally desgned fan wth speed sensor to take advan-
tage of the system fan control.
Important
•
Please refer to the recommended CPU fans at processor's official website or
consult the vendors for proper CPU cooling fan.
•
Fan cooler sets with 3- or 4-pin power connector are both available.
Serial ATA Connector: SATA1
Ths connector s a hgh-speed Seral ATA nterface port. Each connector can
connect to one Seral ATA devce.
Important
Please do not fold the SATA cable into a 90-degree angle. Otherwise, data loss
may occur during transmission.
1
DC-In (9~36V)
2
GND
MS-98D1
MS-98D1
2-7