Restoring data from a tape backup
6-10
Hitachi AMS 2000 Family Copy-on-Write SnapShot User Guide
•
Figure 6-1: Backing-up to Tape
Data can be restored from a tape backup to a V-VOL or P-VOL.
Restoring to the V-VOL results in less impact on your SnapShot
system and on performance.
•
If restoring to the V-VOL:
-
Data must be restored to the V-VOL from which the tape
backup was made.
-
Data can then be restored from the V-VOL to the P-VOL. The
P-VOL must be unmounted before its restoration.
-
Data pool capacity should be 1.5-times the capacity of the
P-VOL.
•
If restoring to the P-VOL:
-
Unmount the P-VOL.
-
Return all pairs to Simplex (recommended in order to
reduce build-up of data in the data pool and impact to
performance).
-
Use this method when the V-VOL is in Failure status (V-VOL
data is corrupt), or when capacity of the data pool is less
than 1.5-times the capacity of the P-VOL.
Using SnapShot