Auro Installation - Samson AURO5 Owner's Manual

Two-way playback monitors

Hide thumbs

Table Of Contents

Table of Contents

Available languages

You can mount the Auro Series

speakers on a wall or ceil-

ing using the included metal

mounting bracket. You can po-

sition the Auro speaker either

vertically or horizontally. In the

vertical position you can direct

the sound left and right. In the

horizontal position you can

direct the sound up or down.

In figure 1, you can see the

installation for an Auro series

speaker mounted in the

horizontal position. Follow

the steps below to hang your

speaker. You can turn the logo

by lifting the corner and twist-

ing 90 degrees.

IMPORTANT NOTE:

IMPORTANT NOT

Only licensed and insured professional sound contractors should install the Auro

Speaker using the installation bracket. Samson assumes no liability for any instal-

lation.

• Remove the ABS plastic insert on the top and bottom of the Auro speaker.

• Mount the metal bracket on the wall or ceiling using the appropriate hard-

ware suitable for the building material you are attaching to.

• Slide the Auro speaker into the metal bracket keeping the ends of the

bracket inside the top and bottom bracket channels.

• Insert the thumbscrews through the mounting bracket and into the thread-

ed inserts, then tighten the thumbscrew, but not all the way.

Important Note: Be careful to insert the thumbscrews straight and do not

Important Note:

cross-thread the thumbscrews.

• Position the Auro to the desired angle, and then, fully tighten the thumb-

screw.