Powering The Auro Series - Samson AURO5 Owner's Manual

Setting up & Operating the Auro Series
It is important that your monitor system is connected in phase otherwise you will It is important that your monitor system is connected in phase otherwise you will
not have the proper low-end response and stereo image.
Note Note: It's fairly easy to identify a monitor that is out of phase just by listening, espe-
cially on a pop record. Listen for the parts of the music that you would expect to be in cially on a pop record. Listen for the parts of the music that you would expect to be in
the center of the mix like kick drum and vocals. If you do not hear them directly in the the center of the mix like kick drum and vocals. If you do not hear them directly in the
center (for instance they sound like they are two signals panned hard right and left) center (for instance they sound like they are two signals panned hard right and left)
then you are more than likely listening to an out-of-phase monitor system. (This test then you are more than likely listening to an out-of-phase monitor system. (This test
won't work on early Beatles records where Ringo's drum kit is panned all the way to the won't work on early Beatles records where Ringo's drum kit is panned all the way to the
right side. Try a Madonna record.) right side. Try a Madonna record.)
In order to ensure that your monitor system is in phase, be careful to pay close
attention to the positive and negative marking on the amplifier, wires and Auro attention to the positive and negative marking on the amplifier, wires and Auro
Series monitors. Make sure that the + terminal of the speaker is connected to the Series monitors. Make sure that the + terminal of the speaker is connected to the
+ terminal of the power amplifier and that the - terminal of the speaker is con- + terminal of the power amplifier and that the - terminal of the speaker is con-
nected to the - terminal of the power amplifier. nected to the - terminal of the power amplifier.

Powering the Auro Series

Powering the Auro Series
The Auro Series monitors have Peak power ratings of 100 to 220 watts and thanks The Auro Series monitors have Peak power ratings of 100 to 220 watts and thanks The Auro Series monitors have Peak power ratings of 100 to 220 watts and thanks
to the robust drivers and crossover components and efficient design, you can to the robust drivers and crossover components and efficient design, you can
use any amplifier with a power rating of 60 to 240 watts. Using a power amplifier use any amplifier with a power rating of 60 to 240 watts. Using a power amplifier
with too low of a power rating can be dangerous since the inputs signal is often with too low of a power rating can be dangerous since the inputs signal is often
clipped in an effort to get the desired level. Over powering the Auro Series can clipped in an effort to get the desired level. Over powering the Auro Series can
result in catastrophic failure and therefore using any amplifier with a power rating result in catastrophic failure and therefore using any amplifier with a power rating
over 250 watts will void your warranty. For the best results use a quality power over 250 watts will void your warranty. For the best results use a quality power
amplifier with a power rating of about 85-100 watts at 4 ohms like the Samson amplifier with a power rating of about 85-100 watts at 4 ohms like the Samson
Servo 170. Servo
S E R V O 1 7 0 S T U D IO A M P L IF IE R
!
FUSE CAUTION
6A/250V
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
HEATSINK MAY BE HOT!
DO NOT BLOCK AIRFLOW
OR OVERHEATING MAY
CAUTION ; REPLACE WITH
OCCUR.
THE SAME TYPE FUSE AS
INDICATED. UTILISER UN
~AC INPUT
FUSIBLE DE RECHANGE DE
115V/60Hz, 490W
MEME TYPE. S/N
USE CLASS 2 WIRING MINIMUM LOAD IMPEDANCE 4
RIGHT LEFT
+RIGHT GROUND LEFT+
SAMSON
TO PREVENT SHOCK DO NOT
OPEN. NO USER SERVICABLE
PARTS INSIDE. REFER SERVICING
T O Q U A L I F I E D S E R V I C E
PERSONNEL. TO PREVENT FIRE
OR SHOCK HAZARD DO NOT
EXPOSE TO RAIN OR MOISTURE.
R L
(UNBALANCED 10K /0dBM)
RIGHT
INPUTS
(BALANCED 10K /0dBM)
FROM MIXER
7
LEFT