Decoder Data; Output - International Datacasting STAR Generation 2 User Manual

Decoder Data

CHANNEL x Data:
STREAM: when stream = MPE (in menu DECODER>AUDIO) then:
MODE: OFF, ANC. DATA AUDIO CH1 (Data on Channel xA), ASYNC. DATA (Data on channel xB).
Note: ANC. DATA is data transport in the ancillary field of coded audio. ASYNC. DATA is data
transport in the MPE RTP header of audio stream.
STREAM: when stream = PES (in menu DECODER>AUDIO) then:
MODE: OFF, ANC. DATA (data on Channel xA), PRIV. DATA (data on Channel xB).
Note: ANC. DATA is data transport in the ancillary field of coded audio. PRIV. DATA is data
transport in a separate PID of the transport stream.
FORMAT: IRT, J.52.
Note: these formats for embedded Async data are only available if Device Special 2 is installed.
PROCESS: MUX, OFF.
BAUD: Output baud rate of the Anc/Async data: 1200, 2400, 4800, 9600, 19k2, 38k4, 57k6 baud.

Output

MODE: Auto (up to 1GB), 100Mb HD, 100Mb FD.
IP ADDRESS: The source address of the output stream.
OUTPUT STREAM: Enabled,
Note: In Disabled mode the (multicast) IP Address and UDP Port are not available.
Note: ASI-OUT is available only with Factory installed option: ASI-OUT.
S T A R G e n 2 R e c e i v e r U s e r ' s G u i d e
Page 15 of 47