Motion
Shows the result of motion detected with 15-minute intervals in a scatter chart. Detailed information can be
seen in "See All Data".
4.5 Reset
If your device isn't communicating with the Security Shuttle, your app may ask you to reset your device.
• Press the tamper switch four times within 1.5 seconds and during the 4th press, hold the tamper switch
until the LED lights up. After 3 seconds the LED will turn OFF, and after the next 2 seconds, release the
tamper switch. If the reset was successful, the LED will light on for 1 second. Otherwise, the LED will flash
once.
• Return to the app and follow the onscreen instructions.
4.6 Change Battery
When the device reports the low battery message you should replace the battery with a new one. The
battery type is CR123A, 3.0V.
Wi-Fi 3-IN-1 Trio Sensor User Manual
V1 2018