Table of Contents
Advertisement
3.1.3 Removing
1
Loosen the knob bolt [1] of powerhead
connections.
2
Lift the positioning knob [5], and turn
it.
When the positioning knob is lifted,
it can be rotated both clockwise and
counterclockwise by 90°.
3
Pull out the shaft tube [6].
If the shaft tube is hard to remove, hold
it so that the attachment is parallel to
the pipe of the powerhead, and then
pull out it.
4
Turn the positioning knob [5] until it
comes to the center.
When the positioning knob is returned
to the center, it will be released
downward.
[1]
[5]
[5]
[6]
19
Advertisement
Table of Contents
