Operating The Seat Cushion; Replacing The Fuse - ULTIMATE SPEED UASB 12 A1 Operating Instructions Manual

Operating the seat cushion

♦ Plug the 12 V vehicle connector
5
♦ Turn the on/off switch
♦ Turn the on/off switch
♦ After using the seat cushion, disconnect the 12 V vehicle connector
the cigarette lighter.
NOTE
► The seat cushion
must be disconnected from the on-board power supply after use! Other-
wise, depending on the vehicle type, the battery will be discharged if the
motor is switched off .

Replacing the fuse

There is a fuse in the 12 V vehicle connector
board power supply. If the product no longer works, check the fuse and replace
if necessary.
♦ Open the 12 V vehicle connector
insert
♦ Now remove the connector tip
♦ Now place a new fuse of type F5AL 250 V into the 12 V vehicle connec-
tor
screw the previously removed screw insert
NOTE
► If the product still does not function, or the fuse blows again immediately,
there is a defect. Please then contact the Service Hotline (see chapter
Service).
UASB 12 A1
illuminates.
3 into position "I" to switch the seat cushion
3 into position "0" to switch the seat cushion
also consumes power in standby mode and therefore
anticlockwise (using pliers if necessary) and remove it.
C
4 ,place the plug tip
B
4 into the cigarette lighter. The Power LED
4 for protecting the vehicle's on-
4
by gently turning the fl uted screw
from the fuse and remove the fuse
B A
onto the slightly protruding end of the fuse and
back in.
C
on.
off .
4
from
.
A
A B C
GB
9