Table of Contents
Advertisement
1. Hardware
2. NI Vision Acquisition Software
3. Getting Started Guide
Installing the Software
Close any applications before upgrading your software. You must be an Administrator to
install NI software on your computer.
1.
Install LabVIEW 2017 or later and LabVIEW FPGA 2017 or later.
2.
Install the NI Vision Acquisition Software 18.5.
Installing the NI PCIe-1477
The following instructions are for general installation. Refer to the documentation provided by
your computer manufacturer for specific instructions and warnings.
What to Use
•
NI PCIe-1477
•
Camera Link-compatible camera
•
One (base) or two (medium/full/extended) Camera Link cables with a 26-pin SDR
connector on the end for the NI PCIe-1477
•
Computer running Microsoft Windows 7 SP1 (32- or 64-bit) or later with at least one
available x8 or larger PCIe slot and a 6-pin (2 x 3) PCIe auxiliary power connector if
using PoCL
•
Tools for PCIe card installation (refer to the documentation provided by your computer
manufacturer)
•
NI Vision Acquisition Software
What to Do
1.
Install NI Vision Acquisition Software before installing the NI PCIe-1477. Refer to the
NI Vision Acquisition Software Release Notes for specific installation instructions.
2.
Power off and unplug the computer.
4 | ni.com | NI PCIe-1477 Getting Started Guide
Figure 1. NI PCIe-1477 Kit Contents
1
2
3
Advertisement
Table of Contents
