Maintenance; Troubleshooting - Hatco 120 User Manual

HATO 120 / 200 SECTIONAL DOOR OPERATOR USER'S
MANUAL
+24V PE

8. Maintenance

•
Check the door once a month. The door should be carefully checked for balance. The
door must be in good working order.
•
The auto-reverse function should be regularly inspected, and adjusted if necessary. For
service, call an experienced serviceman.
•
We suggest for safety reasons, photocells be used on all doors.
•
Disconnect from mains supply before replacing bulb.
•
Be sure to read the entire manual before attempting to perform any installation or service
to the door operator.
•
Our company reserves the right to change the design and specification without prior
notification.

9. Troubleshooting

Trouble
The door fails to open
and close. LED display
does not light.
The door can open, fails
to close.
Remote control does not
work.
The transmitter operating
distance is too short.
CONFORMITY DECLARATION:
It's in accordance with Machine Directive 2006/42/WE and following modify.
It's in accordance with the following directive CE:
Electromagnetic compatibility Directive 2014/30/UE and following modify.
Low tension Directive 2014/35/UE and following modify.
Radio directive RED 2014/53/UE
Have been applied the following harmonized norms:
EN ISO 12100:2012; EN 60204-1:2010; EN 60335-2-95:2015, EN 301 489-3 V1.4.1:2006; UNI EN 12453:2002,
where applicable EN 12445:2002
Current declaration are available on website
GND PB
Wall switch
Fig.20

Possible causes
1. Power is OFF
2. Fuse blown
1. Infrared beam is obstructed.
2.Infrared photocell
enable, but the photocell has not
been installed.
1. Battery level may be low,
2. Transmitter
Battery level may be low.
13
+24V PE GND PB
Phocell receiver Phocell transmitter
1. Make sure that power is ON.
2. Replace fuse.
1. Remove obstructions.
function is 2.Make
photocell function is disable.
1. Replace the battery inside
the transmitter.
2. Re-program the transmitter.
Replace battery.
Solutions
sure the infrared