Aviosys IP Power 9258AU User Manual page 25

Beeper: This will enable or disable the beep on the device as setting or receive
any command.
Leakage:
Set as " Ignore " : 9258xx ignore if there is leakage in the power circuit and thi
sis our default setting.
Set as " Shutdown " : All the 4 power outputs will turn off if leakage over 3mA
in this power circuit environment. This function also help user to check if leakage
in this environment . User can disable this function by select " ignore" . You can
see alarm message as there is leakage as following pictures: .
.
Http Command Verification : This will enable or disable the http commands for
the 9258xx.
Delay Switch: The Delay switch will delay the device to activate the command to
a designated amount of time. If set to 10 seconds after commands during
scheduler or http commands are sent there will be a 10 second delay.
Device Name: Select the name for the device here, and this name will be used
for registering the device on IP Service.
Firmware: Will provide information on the current firmware for the device
- 25-
Ref#92550806002