Bosch CR 400 Owner's Manual page 37

Info
Heating
Heating circuit 1 ... 8
DHW
DHW system I ... II
Solar
Solar sensors
Solar yield
Outdoor temp.
Outdoor temp. curve
Outdoor temp.
Fig. 5 Menu structure of the info menu
1) Only available if a MB LAN2 communication module or an
appliance electronics with integrated communication
interface (MX 25) is installed.
2) Only available without cascade module (e.g. MC400) for
certain types of heat source.
CR 400 | CW 400 | CW 800
Set room temp.
Actual room temp.
Actual flow temp.
Operating Mode
Set temp.
Actual temp.
Therm. disinf. DHW cyl.
Calling up information about the system | 37
Internet
IP connection
Server connection
SW version
Login data
MAC address
System information
Burner starts
Burner runtime
Water pressure
Operating code
Energy consumption
24h: gas heating
24h: elec. heating
24h: gas DHW
24h: elec. DHW
30d: gas heating
30d: elec. heating
30d: gas DHW
30d: elec. DHW
Menu: Heating
The menu items in this menu are only available for installed
heating circuits.
Menu item Description
Set room The desired room temperature that is
temp. currently valid in the selected heating circuit:
• In automatic mode, the desired room
temperature can change several times a
day, if necessary.
• In manual operation, it is always constant
Actual room Currently measured room temperature in the
temp. selected heating circuit
Actual flow Currently measured flow temperature in the
temp. selected heating circuit
Operating Currently valid operating mode in the
Mode selected heating circuit (Off, Heating,
Setback, Summer, Holiday or Manual)
Table 31 Information about the heating
1)
2)
2)
6 720 815 820-61.1O
6 720 820 871 (2016/12)