Passenger Seat (X2); Seat Conversion - Polaris Sportsman 570 2018 Owner's Manual

FEATURES AND CONTROLS

PASSENGER SEAT (X2)

Always make sure the passenger seat lock-out is functioning properly before
operating with a passenger.
Do not operate the vehicle with the seat in the 2-up position when operating
without a passenger. Always return the seat to the 1-up position for single-rider
operation.
Never carry cargo in the rear box when operating the ATV in the 2-up mode with
a passenger.

SEAT CONVERSION

To convert the back cargo rack to a passenger backrest, do the following:
1. Make sure the cargo box dump latch is securely latched.
2. Slide the seat latch levers inward to release the locks.
3. Tilt the backrest slightly forward.
4. Pull the passenger backrest upward from the bed of the cargo box.
5. Lift the adjustment latch at the top of the passenger backrest. Raise the
backrest to the desired position. Release the latch, making sure it locks into
one of the three operating positions.
The backrest must be moved out of the lowest position before it can be
secured in the upright position. The lowest position is for seat storage only. Do
not leave the backrest in the lowest position. Always adjust the backrest to one
6. Lower the operator backrest to create the passenger seat. Two retaining pins
under the seat should fit into the two grommets on the seat base.
7. Test the passenger seat lockout by attempting to release the cargo box dump
latch. If the dump latch releases, the seat is not secure. Repeat the set-up
procedure. If the lock-out is not working properly, do not allow a passenger to
ride the vehicle. See your POLARIS dealer for service.
8. To return the vehicle to single-rider operation, reverse all steps. Always lower
the passenger backrest to the lowest position before folding it down into the
cargo box. Slide the seat latch levers outward to secure the locks.
36
TIP
of the three operating positions.