High Beam Adjustment - Polaris Sportsman 570 2018 Owner's Manual

HIGH BEAM ADJUSTMENT

The headlight beam can be adjusted slightly upward or downward. Use the
following procedure to make the adjustment.
1. Position the vehicle on a level surface with the headlight approximately 25 ft.
(7.6 m) from a wall
2. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
3. Start the engine. Turn the headlight switch to high beam.
4. Observe the headlight aim on the wall. The most intense part of the headlight
beam should be 2 in. (5 cm) below the mark on the wall
weight on the seat when measuring.
5. 570 SP Models:
The adjustment screw is located on the right side of the headlight pod. To
adjust the beam, loosen the screw. Adjust the headlamp to the desired
position, then tighten the screw.
All Other Models:
The adjustment knob is located on the right side of the headlight pod. Adjust
the beam to the desired position by turning the knob either clockwise or
counter-clockwise.
q
. Place the transmission in PARK.
MAINTENANCE
w
. Include rider
111