Table of Contents
Advertisement
Installing a control enclosure and one or more expansion
enclosures
If you are installing a control enclosure plus one or more expansion enclosures,
follow these guidelines.
v A Storwize V7000 system can support up to 1056 drives installed into control
v Each assembled enclosure weighs more than 36kg. There must be sufficient
v Each system can consist of up to four control enclosures. Each control enclosure
v For best performance, the total number of expansion enclosures to be installed
v Where expansion enclosures are to be installed, distribute them evenly into rack
v Leave space in the rack for future expansion enclosures, but otherwise install all
v If a rack is to be only partially filled, install the enclosures low enough for the
Adding an expansion enclosure to an existing system
If you are adding an expansion enclosure to an existing system, follow these
guidelines.
v You do not need to power off the system. You can add an expansion enclosure
v Add the first expansion enclosure directly below the control enclosure.
v Add the second expansion enclosure directly above the control enclosure.
v Add the third expansion enclosure directly below the first.
v Add the fourth expansion directly above the second, and so on.
10
Storwize V7000 Gen2: Quick Installation Guide
and expansion enclosures. Each enclosure requires 2U of rack space.
space at the front of the rack for three persons to carry the enclosure safely.
can be connected to up to 20 expansion enclosures (two SAS chains of up to 10
expansion enclosures each).
should be divided between each control enclosure in the system.
space above and below the control enclosure that they will connect to, without
leaving gaps between the enclosures. This aids cabling and serviceability.
enclosures that constitute one system in adjacent or nearby rack space.
rack to remain stable and enable easy access to the enclosures for servicing.
while the system is operational.
Advertisement
Table of Contents
