Troubleshooting 21 - Woods BRUSHBULL BB6000X Operator's Manual

PROBLEM
Grass cut lower in center of swath
than at edge
Streaking conditions in swath
Material discharges from cutter
unevenly; bunches of material
along swath
Cutter will not cut all the time
(Slip clutch drive only)
MAN0680 (11/3/2007)
TROUBLESHOOTING
MOWING CONDITIONS
POSSIBLE CAUSE
Height of cutter lower at rear or
front
Conditions too wet for mowing
Blades unable to cut that part of
grass pressed by path of tractor
tires
Dull blades
Material too high and too much
material
Grass wet
Rear of cutter too low, trapping
material under cutter
Slip clutch slipping
Adjust cutter height and attitude so
that cutter rear and front are within
1/2" of same height. See Cutting
Height Adjustment, page 15.
Allow grass to dry before mowing.
Slow ground speed of tractor but
keep engine running at full PTO
rpm. Cutting lower will help.
Sharpen or replace blades.
Reduce ground speed but
maintain 540 rpm at tractor PTO or
make two passes over material.
Raise cutter for the first pass and
lower to desired height for the
second and cut at 90° to first pass.
Raise rear of cutter high enough to
permit material to discharge but
not so high to cause conditions
listed above.
Allow grass to dry before mowing.
Slow ground speed of tractor but
keep engine running at full PTO
rpm. Cutting lower will help.
Adjust cutter height and attitude.
Adjust slip clutch according to
instructions in SLIP CLUTCH
ADJUSTMENT, page 18.

Troubleshooting 21

SOLUTION