Operation - Ryobi C358 Operator's Manual

CAUTION:
Do not start the abrasive cut-off machine without check-
ing for interference between the wheel and the machine
base support. Damage may result to the wheel if it
strikes the machine base support during operation of the
machine.
n Tighten the depth stop bolt with the hex wrench
provided.
WARNING:
Cutting steel will cause sparks. Do not operate in
the presence of combustible or flammable materials.
Failure to heed this warning could result in a fire or
serious personal injury.
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
ASSEMBLY
DEPTH STOP
BOLT
TO RAISE

OPERATION

WARNING:
Do not attempt to cut wood or masonry with this cut-off
machine. Never cut magnesium or magnesium alloy with
this machine. Failure to comply could result in serious
personal injury.
WARNING:
Never install any wood cutting blade on this machine.
The cut-off machine is properly guarded only for cutting
metal with an abrasive wheel. Failure to comply could
result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
n Cutting most types of metals such as 2 in. x 6 in. steel
framing studs.
n Cutting hard metal iron stock such as square bar stock
and angle iron.
n Cutting metal tube and pipe stock.
15
DEPTH STOP
BOLT
TO LOWER
Fig. 11