ReSound Micro Mic Quick Manual

Quick guide
– GETTING STARTED
GETTING STARTED
(Charge the Micro Mic and pair to aids before use)
1. Turn on the Micro Mic: Push and hold the power button
the top of the Micro Mic until the status light
2. Connect your hearing aids to the Micro Mic: Push and hold
the program button/toggle button on your hearing aids until
you hear a melody.
Check the connection by blowing or tapping on the Micro Mic.
This sound should be audible in your hearing aids. If this is not
the case, see troubleshooting guide on the reverse page.
3. To exit the Micro Mic streaming program: Push the program
button/toggle button on your hearing aids. Your hearing aids will
return to the most recent hearing aid program indicated by one
or more beeps.
4. Turn off the Micro Mic: Push and hold the power button until the
status light turns red and then off.
STATUS LIGHT
B
• Will blink green every other second when
the Micro Mic is turned on and charged.
• Will blink orange every second when there
are less than 30 minutes of battery left.
C VOLUME CONTROL
Use the volume buttons on the side of the
Micro Mic to adjust the volume. Press '+' to
increase the volume and '-' to decrease the
volume. The mute/volume light
each time the volume is
adjusted.
USB charger
A
on
B blinks green.
MUTE
D
To mute the Micro Mic press the mute button.
Now the mute/volume status light
orange every second. To unmute press the
mute button again, the mute/volume light will
stop blinking.
E will blink
D Mute
F
Volume control C
CHARGING
F
• Insert the charger in the micro USB plug in
the bottom of the Micro Mic.
• Status light indications when charging:
Power/Charging
Powered Off
Powered On
E will blink
E Mute/Volume light
A
Power button
Status light
B
Charging Fully charged