ReSound Clip-On Quick Manual

GETTING STARTED (Quick guide) A
CHARGE YOUR CLIP-ON MICROPHONE
Clip-On Microphone
1. Plug one end of the
charging cable into the
Clip-On Microphone.
Before you can use your NOTE! Check with your
2. Plug the other end of
Clip-On Microphone it is hearing healthcare profes-
the charging cable into
necessary to: sional to determine if your
a power outlet.
instruments have been
• Charge your Clip-On
3. Generally, charging is
pre-paired. Instruments
Microphone for at least
that have been pre-paired complete when the red
3 hours.
LED indicator turns solid
do not need to be paired
again. green interrupted by a red
• Pair with your hearing
blink every 2 seconds.
instruments.
However, when charging
for the first time allow it
to charge for at least 3
hours, even if the battery
indicator indicates that the
battery is fully charged.
17766144-US-13.08-Rev.A.indd 1
B
PAIR WITH YOUR HEARING INSTRUMENTS
PAIRING THE CLIP-ON MICRO-
PHONE IN CHANNEL 1
1.
1. Turn on your Clip-On
Microphone by sliding the
1. ON/OFF switch down to On/Off
2.
the ON position. switch
2.
2. Open the battery doors
on both hearing instru-
ments.
3. Remove the cover from
3.
the Clip-On Microphone.
3.
Press the pairing button
once to put the Clip-On
Microphone in pairing
mode for 20 seconds.
4. The LED indicator will PAIRING THE CLIP-ON MICROPHONE IN CHANNELS 2 OR 3
now blink yellow once 4.
every 2 seconds to indi-
It is possible to pair up to
cate that it is ready to be
three streaming accessories
paired in channel 1.
with a given pair of hearing
instruments.
5. While in pairing mode
close the battery doors To pair a Clip-On Micro-
on both hearing instru- 5. phone in channel 2:
ments.
• Follow steps 1 and 2
under B
6. Successful pairing
will be indicated by an
• Then press the pairing
audible melody played in
button of the Clip-On
both hearing instruments.
Microphone TWO times.
Replace the cover on
The LED indicator will
the Clip-On Microphone
now blink yellow twice
once pairing is complete.
every 2 seconds to indi-
cate that it is ready to be
paired in channel 2.
C
LISTENING TO SOUND FROM YOUR
CLIP-ON MICROPHONE
To pair a Clip-On Micro-
Turn on the Clip-On Micro-
phone in channel 3:
phone and make sure your
hearing instruments are
• Follow steps 1 and 2
turned on. Streaming may
B
under .
be started in one of two
• Then press the pairing ways:
button THREE times.
OPTION A: Press and hold
The LED indicator will blink
the push button on both
.
yellow three times every
hearing instruments for
2 seconds.
about 3 seconds;
Finish by closing the battery OR:
door on both hearing instru-
OPTION B: If you have a
ments.
compatible Remote Control
(optional), simply press the
streaming button.
Once the Clip-On Micro-
phone has been connected
an audible melody will play
in your hearing instruments.
This will be followed by ei-
ther the sound coming from
the Clip-On Microphone or
the sound coming from a
connected auxiliary audio
device (See section D).
Streaming
button
16-08-2013 11:53:58