Cleaning And Maintenance - BOMANN GSPE 887 Instruction Manual

Built-in dishwasher

Hide thumbs

Table Of Contents

Table of Contents

WARNING:

• Always turn off the appliance and disconnect it from the power supply before cleaning and user mainte-

nance.

• Allow the appliance to cool down sufficient before cleaning.

• Do not use steam cleaners for cleaning the appliance; moisture could enter electrical components. Risk of

electric shock!

electric shock! Hot steam could damage the plastic parts. The appliance must be dry before restarting op-

electric shock!

eration.

CAUTION: : : :

CAUTION

• Do not use a wire brush or other sharp, abrasive items.

• Do not use any acidic or abrasive detergents.

NOTE: : : :

NOTE

Dirty filters and clogged spray arms degrade the rinsing. Regularly check the filter and spray arms and clean

them if necessary.

Filter system

Filter

system

Filter

system

The three-part filter system prevents larger amounts of food or other objects from getting inside the pump.

1: Main filter: food and soil particles trapped in this filter are pulverized by a special jet on the

lower spray arm and washed down to drain.

2: Coarse filter: filters out larger items such as pieces of bone or glass shards that could

block the drainage.

3: Micro filter: filters dirt and food residues in the sump area and prevents it from being redeposited on the

dishware during rinse cycle.

Cleaning the filter system

CAUTION:

• The dishwasher must never be used without the filter.

• Improper replacement of the filter can reduce performance and damage the appliance.

• Do not knock out the filter for cleaning to avoid possible deformations of the filters.

NOTE

NOTE: : : :

NOTE

Check after each rinsing the filter for residues.

• Turn the filter unit (coarse/micro filter) counterclockwise and remove it.

• Loosen the coarse filter from the micro filter by gently pushing the side levers and take it up-

wards.

• Take out the main filter to the front.

• Remove leftover food and clean the filter under running water. Use a soft brush for the coarse

and micro filter, if necessary.

• Put the filter system properly in reverse order together and reinstall in its provided position.

Fix the entire system, by tightening the filter unit clockwise.