Troubleshooting - Ryobi AIRgrip ELL0001 Operator's Manual

PROBLEM
Laser line projection is
weak.
Laser is off, but motor is
on and vacuum is working.
Laser line is hard to see.
Laser line is not level.
Laser line is horizontal
when a vertical line is
desired.

TROUBLESHOOTING

CAUSE
Batteries are low.
Batteries are low.
Light in area is too bright.
1. Leveling bubbles not
properly aligned.
2. Level is mounted on
base that isn't level.
Laser lens is in the
incorrect position.
Replace with fresh
batteries.
Replace with fresh
batteries.
Use in dimmer area or use
laser-enhancing glasses.
1. Make sure bubble on
2. Make sure the bubbles
Turn the laser lens 90˚ to
the vertical orientation.
16
SOLUTION
vial is centered.
are level after mounting
to base.