Table of Contents
Advertisement
Submenu
e-shift
INSTALLATION menu
Submenu
Projector Mode
Test Pattern
Lamp Settings
12V Trigger
24
Menu Functions
Switches the display resolution.
•
Off: Switches to 2K resolution.
Picture Mode will automatically be set to fixed mode.
•
On (recommended): Switches to 4K resolution.
See
"Choosing a location"
Is used to adjust the image size and focus
and check that the projected image is free
from distortion. To close the test pattern,
go back to this menu and select Off.
•
Lamp Mode
Select the projector lamp power from the following modes.
•
Normal: Provides full lamp brightness.
•
Eco: Reduces system noise and lamp power consumption by 30%.
If the Eco mode is selected, the light output will be reduced and result in darker
projected pictures. See
•
Reset Lamp Timer
Activate this function only after a new lamp is installed. When you select Reset,
a "Reset Successfully" message displays to notify that the lamp time has
been reset to "0".
•
Lamp Information
Select to learn the duration (in hours) of lamp usage which is automatically
calculated by the built-in timer.
There is one 12V trigger that works according to your needs for installation
scenarios. Two selections are available:
•
Off: If this is selected, the projector will not send electronic signal out
when it is turned on.
•
On: The projector will send a low to high electronic signal out when it is
turned on, a high to low signal out when it is turned off.
Functions and Descriptions
Functions and Descriptions
for details.
"Setting Lamp Mode"
for details.
Hide quick links:
Advertisement
Table of Contents
