Makita DUX60 Instruction Manual page 8

Tool / battery protection system
placed under one of the following conditions:
Status
On
Overload
Overheat
Over
discharge
Overload protection
debris, and the middle indicators start blinking and
In this situation, turn the tool off and stop the application
that caused the tool to become overloaded. Then turn
the tool on to restart.
Overheat protection for tool or battery
When a over heating occurs, all speed indicators blink.
Overdischarge protection
indicator blinks.
If the tool does not operate even when the switches are operated,
remove the batteries from the tool and charge the batteries.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
1. Indicator lamps 2. Check button
Indicator lamps
Off Blinking
1
2
light up for a few seconds.
-
Indicator lamps
-
Lighted
NOTE: Depending on the conditions of use and the
Main power switch
WARNING:
switch when not in use.
the main power lamp lights up. To turn off, press the
main power button again.
1
1. Main power button
NOTE: The main power lamp brinks if the switch
trigger is pulled under unoperatable conditions. The
holding down the lock-off lever and the switch trigger
NOTE:
To avoid unintentional start up, the main power switch
is not pulled for a certain period after the main power
switch is turned on.
8 ENGLISH
Off Blinking
Always turn off the main power
-
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
malfunctioned.