Table of Contents
Advertisement
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your drill-driver continuously, the batteries in
your battery pack become hot. You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
To preserve natural resources, please
Y
recycle or dispose of batteries properly.
R B R C
This product contains nickel-cadmium
battery. Local, state, or federal laws may
N i C d
prohibit disposal of Nickel-Cadmium
batteries in ordinary trash. Consult your
local waste authority for information
regarding available recycling and/or
disposal options.
For more information on battery recycling
call 1-800-8 BATTERY.
WARNING:
Do not attempt to disassemble the battery pack. Fire or
injury can result.
WARNING:
The operation of any power tool can result in foreign objects being thrown into your
eyes, which can result in severe eye damage. Before beginning power tool operation,
always wear safety goggles or safety glasses with side shields and a full face shield
when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or
standard safety glasses with side shields.
SPECIFICATIONS:
Model
Chuck
Motor
Switch
No Load Speed
Clutch
Charger Input
Charge Rate
DISPOSAL OF THE EXHAUSTED BATTERY
Page 6
HP1201M
3/8 in. Keyless
DC Motor 12.0V
Variable Speed
0 - 550 RPM
24 Positions
120V, 60 Hz, AC Only
3-6 Hours
occur under normal circumstances. Refer to "Charging
Your Drill-Driver" for normal recharging of batteries. If the
charger/charging assembly does not charge your battery
pack under normal circumstances, return both the battery
pack and charger/charging assembly to your nearest Ryobi
Authorized Service Center for electrical check.
BATTERY PACK PREPARATION FOR
RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with
heavy duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its
components. Also, never touch both terminals with metal
objects and/or body parts, as short circuit can result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
Advertisement
Table of Contents
