Window 3PNC28000 User Manual page 11

FIG. 13
STEP 5:
INSTALL SUPPORT BRACKET
1. Hold each support bracket flush against outside
of sill and tighten to bottom of cabinet as shown
in Fig. 15A. Mark brackets at top level of sill,
and remove.
2. Assemble sill angle bracket to support brackets at
the marked position. (See Fig. 15B.) Hand tighten,
but allow for changes later.
NOTE: Check that air conditioner is tilted back about
1 1 / " to 1 5 / " (tilted about 3º to 4º downward toward
2 8
the outside). If, after proper installation, condensation
does not drain from the overflow drain hole during
normal use, adjust slope. (Fig 14)
Window Sash
Measure from the
cabinet edge.
FIG. 14
Sill Angle Bracket
Window Sill
FIG. 15A
Mark
Bottom
Rail Seal
3/4" (or 1/2") long
Hex-head Screw
About 1
5 to 1
Side Louvers
Locknut
Sill Angle
Bracket
Flat Head
Bolt
3. Install support brackets (with sill angle brackets
attached) to correct hole in bottom of cabinet as
shown in Fig. 16.
4. Securely tighten all 6 bolts.
/ "
1
2
/ "
5
8
STEP 6:
EXTEND ACCORDION PANELS
1. Carefully raise window to expose accordion panel
locking screws. Loosen screws so accordion
panels slide easily.
2. Extend panels to fill window opening completely.
Tighten locking screws on top (Fig. 17A).
3. Close window behind top angle.
1/2" Log Screws
Left
and Locknuts
2 Each Required for
Each Support Bracket
FIG. 15B
FIG. 16
Locking Screw
FIG. 17A
Right
1/2" Long
Screws and
Locknuts
7/16" Locking
Screw and
Washer
8