Buttons - FibroPool FH-020 Operation And Installation Manual

Buttons

Unit ON/OFF button
USE THIS BUTTON TO TURN THE UNIT ON or OFF.
Unit is ON when clock, running mode and timing state are displayed on screen.
Mode button
Press this button to select the running mode at any time. Each time this button is pressed, the
HEATER will cycle between one of four modes IF AVAILABLE. It will illuminate the Mode the heater is
in, such as "Heating" or "Cooling"
Timer ON button
Press this button when the unit is not in clock setting. Set desired hour and minute, then press
once more to exit timing boot setting. In the corresponding conditions, press"
corresponding time value.
Timer OFF button.
Press this button when the unit is not in clock setting condition, the unit can be turned into timing
shutdown setting condition, press this button again to set hour and minute ,press it one more time
to exit timing shutdown setting. In the corresponding conditions, press"
time value.In timing shutdown setting condition,press ""can cancel timing shutdown function.
Timer Button
Press "" directly entering into Timer Settings, the"88.88"flashing, then press""to set Hour with"
,and press "" again to set Minute with "
Timer Setting condition, ""button and ""button invalid.
▲ ▼
" "or" "Button:
Used for the temperature setting, parameter setting, parameter checking, and adjustment of the
timer.
In clock Setting,they are used for adjusting hour and minute
In turn ON/OFF timing setting,they are used for adjusting hour and minute;
In normal condition, press ""button for 5 seconds to enter parameter checking interface, at this
time press ""again enter into parameter setting;In other condition,at the same time
▲ ▼
Press" "and" "5 seconds enter into keyboard lock,press it again at the same time for 5 seconds
exit the keyboard lock.
Press BOTH for 10 seconds, wire control parameter are reset.
▲▼
",then press again to save and complete settings.In
▲▼
" to set the
▲▼
"Set the corresponding
▲▼
"
12