Assembly Instructions; Assembling The Unit; Positioning The Handlebars; Installing The Wheel Bracket Assembly - Ryobi 510r Operator's Manual

ASSEMBLING THE UNIT

Your yard and garden cultivator has been mostly
assembled, except for the wheel bracket assembly.
NOTE: This unit is shipped without oil. In order to avoid
damage to the unit, put oil in the crankcase
before attempting to start it.
Unpacking
1. Carefully unpack the contents and insure that
nothing is damaged.

POSITIONING THE HANDLEBARS

1. Loosen the two knobs on the inside of the
handlebars (Fig. 1).
2. With the unit upright, swing the handlebars up into
the operating position (Fig. 1).
NOTE: Take care not to pinch the throttle cable or
switch wires when positioning the handlebar.
3. Tighten the knobs to secure the handlebars in place.
NOTE: Do not over-tighten the knobs.
4. Readjust the throttle cable and switch wires so they
are smooth and tight against the handlebar
assembly. This will help prevent them catching or
snagging during normal operation.
ADJUSTING THE HANDLEBAR HEIGHT
1. Remove the knobs and mounting bolts and reinstall
them through either the top or bottom holes in the
handlebar assembly (Fig. 2) in order to adjust the
height of the handlebars.
2. Be sure to tighten the knobs to secure the
handlebars in place.
Handlebar
Knobs
Top Hole
Bolt
Bottom Hole
8

ASSEMBLY INSTRUCTIONS

Handlebar
Knobs
Fig. 1
Washer
Handlebar
Knob
Handlebars
Fig. 2

INSTALLING THE WHEEL BRACKET ASSEMBLY

WARNING: To avoid injury from the tines,
wear heavy gloves and a long sleeve shirt
when installing the wheel bracket assembly.
WARNING: To prevent serious personal
injury, install the wheel bracket assembly
when operating the unit.
NOTE: The wheel bracket assembly is located in the
cardboard insert, inside at the top of the carton.
1. With the unit on its side, place the wheel bracket
assembly on the underside of the tine guard (Fig. 3).
2. Install a carriage bolt through each of the slotted
holes in the wheel bracket and into the tine guard.
3. On the TOP side of the tine guard, install a lock
washer and a wing nut onto each of the bolts (Fig. 3).
4. Make sure the square shoulder of the bolts is pushed
through the slotted holes in the wheel bracket.
Tighten the wing nuts (Fig. 4).
NOTE: Do not over-tighten the wing nuts. Loosen the
wing nuts to adjust wheel height.
Tine
Guard
Wing Nut &
Lock Washer
Wheel
Bracket
Assembly
Fig. 3
Fig. 4