Table of Contents
Advertisement
•
Press the soak button to move to the left to the save icon. Note the
save icon will be brighter than everything else.
•
Press the back/set button to save you selection. If you want to cancel
your choice us the temp down button to navigate to the cancel icon or
simply wait 30 seconds which will end the programming session.
Preferences
•
Temp display: Factory set to Fahrenheit "F" but can be changed to Cel-
sius "C" in alignment with local methods of displaying temperature
•
Time display: Factory set to 12 hour but can be changed to 24 hour.
12 hour will display "AM" and "pM" after the time if 12 hour is chosen.
Choosing 24 hour will display the time in military time.
•
Clean-up: Factory set to 30 minutes (.5hr). A clean-up cycle will start
30 minutes after you have finished using the vessel. You have the ability
to extend the clean-up time in .5 hr increments to suit your usage pat-
terns and increase the filtration of the water after use.
•
Language: Factory set to English. Choose between English, Spanish,
French and German to support your specific language in the display.
Diagnostics
•
Vessel, information, A/B Temps and Fault Log are sub menu items used
for troubleshooting issues you may encounter with the vessel operation.
These functions can only be viewed and not changed. Typically these
functions will be used by a service technician but can be helpful to the
owner when reporting an issue to the dealer or service technician over
the phone.
Wi-Fi control: (if equipped)
•
Your vessel is configured with a special component that will allow wire-
less control with most Apple and Android based devices. This is an
exciting feature that allows wireless operation of the vessel functions
and most settings.
•
Please note that the typical operating range is within 30 feet of the ves-
sel depending on obstructions or location/orientation. The signal may
not be strong enough in some cases to adequately establish and hold
communication between the vessel and your device especially when
operating from indoors and the signal has to travel through walls. Keep
this in mind when placing your vessel during installation in an effort to
keep any obstructions to a minimum.
•
Initial set up:
•
In order to communicate and operate the vessel, you will need to go
to the App Store and download the free "Marquis Spas" app to your
device.
•
Go to the settings section on your device and choose the "Wi-Fi" tab.
Be sure that the Wi-Fi selection slider is set to the "On" position so your
device will discover all available Wi-Fi choices. Choose the tab labeled
BWG followed by a series of numbers. Be sure your device connects
which should be shown by the presence of a check mark next to the
name.
operating y o u r atv
Hide quick links:
Advertisement
Table of Contents
