Related Manuals for Attero Tech unAX4I AES67
Summary of Contents for Attero Tech unAX4I AES67
- Page 1 4x2 AES67 Networked Audio Wall Plate User Manual Attero Tech LLC 2018 11/14/2017 614-00042 Rev 01...
-
Page 2: Important Safety Instructions
If Attero Tech, LLC cannot correct the defect in the This symbol, wherever it appears, alerts you to equipment, it will be replaced at no charge with a similar new important operating and maintenance instructions in the item. -
Page 3: Optional Extras
3-gang Decora cover plate). Figure 1 - unAX4I Front Panel The unAX4I AES67 audio interface is a cost effective XLR IO wall plate solution. The unAX4I features four balanced mic/line XLR inputs and two balanced line outputs do de-pluggable connectors on the side of the unit. -
Page 4: Device Installation
2 – Device Installation 2.1 – Mounting A typical installation will involve mounting the wall plate into a pre mounted wall box or mounting bracket. Before installation, make sure the wall box where the unAX4I is to be installed is pre- wired with a suitable cable back to a PoE-enabled network switch or mid-span injector. - Page 5 Figure 3 - Dimensioned Drawing *Note: 2D and 3D CAD models can be downloaded from the Attero Tech customer portal. Please contact Attero Tech for any further product related information that is not accessible on the website. ⁞ ⁞ 1315 Directors Row Suite 107 Fort Wayne, IN 46808 (260)496-9668 www.atterotech.com...
-
Page 6: Error Reporting
2.2 – Error Reporting Balanced The unAX4I is equipped with error reporting features. Upon Unbalanced power up, the front panel power LED will briefly light red and then Source Input change to green if the device boots successfully. If the LED remains on solid red, this indicates a device failure. -
Page 7: Device Configuration
IP. Having successfully completed a factory reset of the device, setting the PC’s IP address to also obtain a The audio routing is also done using Attero Tech’s unIFY Control dynamic IP address should then allow the PC to communicate fully Panel. -
Page 8: Using The Command Interface
UDP interface can be found in the unIFY 3 party Software API document, available from the registered users section of the Attero Tech website (Go to www.atterotech.com and click on the log-in option). 3.5 – Using the Command interface... -
Page 9: Architects & Engineers Specification
Class A) and RoHS requirements. Each XLR input channel shall have +48V phantom power, The unit shall be the Attero Tech unAX4I I/O Interface. selectable via software on a per channel basis. They also have four gain levels: –15dB (pad active), 0dB, +25dB and +40dB, selectable via software on a per channel basis. - Page 10 Document Information Document title: unAX4I Document file name: 614-00042 unAX4I User Manual.docx Revision number: <01> Issued by: Attero Tech Issue Date: 11/14/2017 Released Status: Revision History Revision Date Author Description of change 00_a 08/28/17 Initial Draft 00_b 09/27/17 Updates and changes after review...
-
Page 11: Document Information
Document Information Document title: unAX4I Document file name: 614-00042 unAX4I User Manual.docx Revision number: <01> Issued by: Attero Tech Issue Date: 11/14/2017 Released Status: Revision History Revision Date Author Description of change 11/14/17 Release 01_a 03/15/18 Warranty Updated ⁞ ⁞...
Need help?
Do you have a question about the unAX4I AES67 and is the answer not in the manual?
Questions and answers