Table of Contents
Advertisement
INSTALLER
COMPONENT GUIDE
UNO-S1 Keypad-Update Port
Src 3
OS Update/Run Jumper -The pins are jumpered when performing an OS update on the key-
1
pad, and removed during normal operation.
(Typically needed only on a keypad that has never been updated)
2
Setup Button - Activates information and update menus for the keypad.
OS Update Port - Used to update the UNO-S1 keypad operating system firmware. If an
3
update is released, it will be available online through the Document Center on
www.russound.com. Look for it in the "Firmware and Downloads" section under Multi-Zone
product type. The Advanced Programming Cable is available from Russound, Part #2500-
521065.
26
1
3
2
Data Rx TTL Level
Data Tx TTL Level
GND
+12VDC
Note: Do not put
RS-232-level signals
into the pins. Must use
Advanced
Programming Cable
P/N 2500-521065.
Advertisement
Table of Contents
