Russound CAM6.6T-S1 Instruction Manual page 55

9. SUFFIX CMD –
(Sufix)
10. COMMAND TYPE –
(CmdTp)
a. Selected: Learned IR
(LrnIR)
i. LEARNED SRC –
(LnSrc)
b. Selected: Unassigned
(Unasg)
c. Selected: Default
(Deflt)
d. Selected: Macro:
(Macro)
i. MACRO -
(Macro)
ii. MACRO ID –
(MacID)
e. All Other Selections:
11. DEVICE CODE –
(DevCd)
12. KEY FUNCTION –
(KeyFn)
13. SAVE CHANGES? –
(Save?)
SRC SEL CMD (SrcSC)
This procedure permits a command to be sent to the source component when the source component
is initially selected. See Source Select Command & # Of Sources - Flow Chart on page 69
1. SOURCE NUM –
(Src #)
Tells the system whether a command will be issued after the
selection of the numerical value (e.g., 1, 2 Enter ). If "no," proce-
dure advances to SAVE CHANGES (step 13)
Select the type of source command (e.g., CD, TV, etc.).
Choose Learned IR if the pre-programmed IR code library does
not support the source component.
Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 12)
The numeric IR Suffix command is cleared. Procedure advances
to SOURCE NUM (step 1)
Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 12)
(To build macros, see Macro Editor page 61)
Macro loads a series of commands which are processed when
activated.
Enter the macro ID number. Menu advances to SAVE CHANGES
(step 13)
Procedure advances to DEVICE CODE (step 11)
Source component code for IR control.
Select a function (Enter, Play, etc.).
Select "yes" to save the changes.
Select the source number this command will be configured for.
INSTALLER
INSTALLATION MENU
55