When an error message appears
This section describes how to take action if an error message appears.
When a system BIOS error message appears
If an error is detected during POST, an error message appears on the display.
Take action according to the description mentioned in the "Action" of the table
below. If a message not described in the table should appear, write down the
message and contact the sales representative or maintenance personnel.
Table 6-3: System BIOS error messages during POST
Error
code
Last power event was caused by
2004
CPU1 Thermal Trip
Last power event was caused by
2005
CPU2 Thermal Trip
2008
CPU1 BIST Error is found
2009
CPU2 BIST Error is found
2710
FRU checksum bad
Cannot set BMC network
2714
configuration
2716
BMC is not ready
2717
Power supply configuration error
3B01
System battery is dead
3B02
Check date and time settings
BMC hard fail
-
BMC soft fail
-
BMC communication error
-
Cannot access SDR Repository
-
Cannot access BMC FRU device
-
IPMB Signal lines do not respond
-
SDR Repository empty
-
Internal Use Area of BMC FRU
-
corrupted
Controller updated 'boot block'
-
firmware corrupted
Controller operational firmware
-
corrupted
BMC is in force update mode
-
2630
ME Firmware has stopped
Error message
Troubleshooting
Hitachi Compute Rack 210H User's Guide
Description
A processor error has been detected.
A processor error has been detected.
A processor error has been detected.
A processor error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A power supply configuration error has
been detected.
A battery error has been detected.
A system clock error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A BMC error has been detected.
A firmware error has been detected.
Action
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*2)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
(*1)
6-5