Bank Name; Controller Id; Diagnostics; Factory Initialization - Russound ST2-XM Instruction Manual

ST2-XM TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Memory Name (XM) (continued)
9. Press BAND to advance. MEMORY NAME
appears again.
10. Press BAND to access the Memory Name
entry screen.
11. Press Tune Up/Down to select a character
and MEM Up/Down to change a character
position. Up to 12 characters can be entered
one by one. A blinking cursor indicates the place-
ment of the character being entered.
12. Press BAND when memory name is entered.
13. SAVE CHANGES will appear.
14. Press Tune Up/Down to select Yes or No.
15. Press BAND to save memory name. The
Memory Name menu returns to the Memory #
prompt to name other presets, or press TNR
SEL to return to the Memory Name menu start.
Bank Name (XM)
A custom name can be assigned to each of the
six banks of Tuner 1 (XM).
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press BAND.
3. MEMORY NAME appears. Press MEM
Up/Down until BANK NAME appears on the tuner.
4. Press BAND.
5. Bank # appears.
6. Press the Tune Up/Down buttons to select the
Bank #.
7. Press BAND. BANK NAME appears again.
8. Press BAND to access the Bank Name entry
screen.
9. Press Tune Up/Down to select a character
and MEM Up/Down to change a character posi-
tion. Up to 12 characters can be entered one by
one. A blinking cursor indicates the placement of
the character being entered.
10. Press BAND when bank name is entered.
11. SAVE CHANGES will appear.
12. Press Tune Up/Down to select Yes or No.
13. Press BAND to save bank name. The Bank
30
Name menu returns to the Bank # prompt to
name other banks, or press TNR SEL to exit the
Bank Name menu.
Controller ID (XM)
The Controller ID procedure is used to identify
the controller(s) that the XM tuner will
respond to.
Note: For the XM module that is installed in the
ST2-XM chassis, "All Controllers" will be the
default setting.
Diagnostics (XM)
The Diagnostics procedure is for factory
use only.
Factory Initialization (XM)
The Factory Initialization procedure allows the
erasure of all programmed settings of the XM
tuner and returns them to the factory default set-
tings.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press BAND.
3. MEMORY NAME appears. Press MEM
Up/Down until FACTORY INIT appears on the
tuner.
4. Press BAND to enter the FACTORY INIT menu.
5. "Are you sure" appears on the tuner. Using the
Tune Up/Down buttons, view the "Yes" and "No"
selections.
6. Press BAND to select. A "No" selection
returns to the top of the Factory Init menu. A
"Yes" begins the initialization.
7. "Please wait" appears on the tuner during the
process and "Cycle Power" appears when com-
plete.
8. Cycle power on the ST2-XM tuner.