Table of Contents
Advertisement
ST2-XM OPERATION
ST2-RC REMOTE CONTROL
ST2-RC Remote Control Operation
The ST2-RC remote control is the only means of
remote operation of the ST2-XM in a non--RNET sys-
tem. The ST2-XM front panel displays information for
the tuner that is receiving commands from the ST2-
RC. However, the ST2-RC commands do not change
which tuner is playing; that is done through the sys-
tem's source selection.
Turning the unit on/off
To switch the ST2 tuner in or out of standby mode,
PWR
push
or any other button except TUNER 1 or
TUNER 2.
Selecting the desired tuner
To control a tuner, push
pressed, these buttons will be backlit green for Tuner
1 (XM) and amber for Tuner 2 (AM/FM). Each time a
tuner is selected the display will refresh with the cur-
rent station or preset for that tuner, and all subse-
quent button presses and memory preset entries will
be associated with that selected tuner.
Selecting the desired band (AM/FM only)
AM/FM
Push
to switch between AM and FM reception.
Selecting the desired frequency or channel
Use
and
for manual tuning. To move quickly
through the stations or channels, press and hold
either of the Tune buttons for more than 1.5 seconds.
To directly select a station or channel, press
and enter the two- or three-digit XM channel number,
or the three- or four-digit station frequency (1071 for
107.1, etc.). European regions use five-digit station
frequencies.
Selecting a mode (XM)
OK
Push
to select an XM operating mode.
Exiting a mode (XM)
ST/
Push
to exit the XM operating mode selection
MONO
menu.
20
TUNER 1
TUNER 2
or
. When
TUNE
,
Frequency Seek (AM/FM only)
The SEEK function is performed by pressing and
releasing
to seek lower frequencies or
higher frequencies. SEEK tuning begins at the current
frequency, seeks upward and stops at the next tuned
station. Pushing
continues the SEEK function.
Once the highest frequency is reached, the tuner con-
tinues in SEEK mode at the lowest frequency.
Selecting Stereo or Mono Output
(AM/FM only)
ST/
Press
to toggle between stereo and mono mode.
MONO
STEREO or MONO appears briefly on the screen when
selecting mode. Normal operation is in stereo mode.
On a preset, the stereo/mono setting is saved for
that preset.
Selecting Distant or Local Reception
(AM/FM only)
LOC/
Press
to toggle between Distant and Local
DX
mode. DISTANT or LOCAL appears briefly on the
screen when selecting mode. Normal operation is in
Distant mode.
Recalling a Memory Preset
To recall a memory preset, select the desired tuner,
BANK
press
and enter the desired bank number
MEM
(1-6), then press
and enter the desired preset
number (1 to 6). The memory presets can also be
accessed by using
and
presets for the selected bank.
Saving Favorites
The remote control stores two "favorites" (similar to
memory presets) per tuner. These are set simply by
selecting either Tuner 1 or Tuner 2, setting the
desired frequency and pressing and holding
FAV 2
until "FAV1 (2) saved" appears on the tuner.
Stored Favorites are then recalled by pressing either
FAV 1
FAV 2
or
.
for
to scroll through all
FAV 1
or
Hide quick links:
Advertisement
Table of Contents
