Factory Initialization - Russound ST2-XM Instruction Manual

Press and Hold
TNR SEL button
TNR TNR
SEL SEL
TUNER
SETUP
Menu
4. "Hold BAND" appears on the tuner.
5. While pressing and holding BAND, "After
update cycle power" appears on the tuner
display.
6. When "Start Update" appears on the tuner dis-
play, start the update program. "Finished"
appears on the computer screen when complete.
7. Cycle power to the tuner.
Factory Initialization (Chassis)
The Factory Initialization procedure allows the
erasure of all programmed settings and returns
them to the factory default settings.
1. Enter the Setup Menu by pressing and holding
ST2-XM TUNER PROGRAMMING
ST2 Chassis Setup Procedures
SOURCE
UPDATE
NUM
FIRMW
Procedure
Procedure
TNR TNR
SEL SEL
HOLD
TUNER
BAND
#
After update
cycle Power
SOURCE
NUM
Start
Update
Cycle Power
ST2 TUNER SETUP MENU
FACTORY SYSTEM
INIT INFO
Procedure Procedure
This
Procedure
returns the
ST2 Tuner
to its
Factory
settings
Are you sure
YES
NO
Please wait
Cycle Power
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until FACTORY INIT appears on the tuner.
3. Press BAND to enter the FACTORY INIT menu.
4. "Are you sure" appears on the tuner. Using the
Tune Up/Down buttons, view the "Yes" and "No"
selections.
5. Press BAND to select. A "No" selection
returns to the top of the Factory Init menu. A
"Yes" begins the initialization.
6. "Please wait" appears on the tuner during the
process and "Cycle Power" appears when com-
plete.
7. Cycle power on the ST2-XM tuner.
Chassis
Setup
Menu
TNR
SEL
27