What You Will Need - MFJ -1886TR Instruction Manual

Wiring
1. Connect a coax jumper between the
transceiver and the TRANSCEIVER jack.
2. Connect the Transmit Antenna to the XMIT
ANTENNA jack.
3. Connect the coax betweel the MFJ-1886 Loop
and the LOOP ANTENNA DC-PASS jack
4. Connect and RCA cable between the KEY jack
and the KEY output on the transceiver. This
may be labeled SEND or may be on a jack
labeled REMOTE or ACCESSORY. This is the
line that would be used to key a linear amplifier.
5. Connect up the 12VDC power source that
came with the MFJ-1886.

What You Will Need

1. Coax Jumper between the Switch Box and
the transceiver
2. Coax jumper between the Loop and the
Switch Box.
3. Transmit Antenna.
4. Interface cable to run between the KEY
input and the transceiver Send output.
Mounting
Use the two supplied u-bolts
to secure the loop to your
mast as shown. Your mast
should be no more than
1-3/4 in diameter and should
be sturdy enough to support
the MFJ-1886 antenna.
Transmit Antenna
3
2
1
4
KEY Line
Side view
Customer supplied tripod or mast
DC PASS
LOOP ANTENNA
Line
5
XCVR
ANT