HWH 680 Series Operator's Manual page 10

The vehicle should be level before extending a room.
1. The ignition key must be on and the park brake must be set
for the room to be operated.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
NOTE : Make sure there is adequate clearance to fully extend
the room.
2. Insert the KEY into the KEY SWITCH on the room exten-
sion operator's panel and turn it to the "ON" position. When
the AIR SEAL INDICATOR LIGHT is on the room can be op-
erated.
3. To extend the room, push and hold the ROOM CONTROL
SWITCH in the EXTEND position. When the pump is running,
the red PUMP ON light will be on. When the room is fully ex-
tended, the pump will automatically shut off. Release the
ROOM CONTROL SWITCH.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
The vehicle should be level before retracting a room.
1. The ignition key must be on and the park brake must be set
for the room to be operated.
2. Insert the KEY into the KEY SWITCH on the room exten-
sion operator's panel and turn it to the "ON" position. When
the AIR SEAL INDICATOR LIGHT is on the room can be op-
erated.
3. To retract the room, push and hold the ROOM CONTROL
SWITCH in the RETRACT position. When the pump is run-
ning the red PUMP ON light will be on. When the room is
fully retracted, the pump will automatically shut off. Release
the ROOM CONTROL SWITCH.
IMPORTANT: If the room is fully retracted and the Pump On
light remains on for more than 30 seconds, release the
ROOM CONTROL SWITCH.
OPERATING PROCEDURES
BEDROOM EXTEND PROCEDURE
BEDROOM RETRACT PROCEDURE
IMPORTANT: If the room is fully extended and the Pump On
light stays on for more than 30 seconds, release the ROOM
CONTROL SWITCH.
IMPORTANT: IF EITHER SIDE OF THE ROOM STOPS
MOVING, RELEASE THE ROOM CONTROL SWITCH IM-
MEDIATELY.
NOTE : Releasing the ROOM CONTROL SWITCH will halt
the operation of the room.
4. Turn the KEY SWITCH to the "OFF" position and remove
the key.
5. Turn off the ignition switch.
IMPORTANT: This room is equipped with hydraulic room lock-
ing cylinders. The room can NOT be extended with the locks
in place. DO NOT attempt to force the room out if the room
locks will not disengage.
IMPORTANT: IF EITHER SIDE OF THE ROOM STOPS
MOVING, RELEASE THE ROOM CONTROL SWITCH IM-
MEDIATELY.
NOTE : Releasing the ROOM CONTROL SWITCH will halt
the operation of the room.
4. Turn the KEY SWITCH to the "OFF" position and remove
the key.
5. Turn off the ignition switch.
IN THE EVENT OF THE FAILURE OF THE ROOM TO RE-
TRACT, CONTACT HWH CORPORATION CUSTOMER SER-
VICE AT 1-800-321-3494 FOR ASSISTANCE.
MP35.4760
07APR00