HP 98700H CE Handbook page 18

Carefully remove the HP 98287 A I/O card from its protective bag.
There are two switches on the I/O card used to set the locations that the
HP Human Interface LOOP (HP-HIL) and the HP 98700 will respond
to. Switch 1 is a five section switch that sets the select code of the HP
98700 HP-HIL. Switch 2 is an eight section switch that sets the location
of the HP 98700 control space and frame buffer. For switch location see
Figure 3-5.
Pascal and BASIC operating systems will not support HP-HIL through
the HP 98700H. HP-HIL must be installed through the HP-HIL connec-
tor in the rear panel of the Series 300 computer. Refer to the Installation
Guide for your computer for details.
1. Set the switches as desired. See Figure 2-7.
LSB
HP-HIL
SELECT CODE
SWITCHES
FACTORY
01
0
SETTING~
1
02
FB ADDRESS
0 $200 000
1
$300 000
0 $800 000
$900 000
Figure 2-7. Setting the Switches
2-10
Environmental/Installation/Preventive Maintenance