Dhd Controller Front Panel - Runco Video Xtreme VX-6000d Owner's Operating Manual

Controls and Functions
2.3
DHD Controller Front
Panel
2
1
Figure 2-3. DHD Controller Front Panel
Figure 2-3 shows the controls and indicators on the DHD Controller front panel; the
paragraphs that follow describe them.
1. RUNCO ICON
Lights red to indicate that the DHD Controller is in standby mode; lights blue to
indicate that the unit is on.
2. POWER BUTTON
Press once to toggle from standby mode to on mode. Press it again to return to
standby mode. For a discrete on or off command, you can use the direct access
buttons on the remote control.
3. IR SENSOR
Receives IR commands from the remote.
4. VACUUM FLUORESCENT DISPLAY
Can be used instead of the On-Screen Display (OSD). Displays currently-selected
menu or – if no menu is selected – the current source, signal format (NTSC or PAL),
input resolution and aspect ratio.
5. UP BUTTON
Used to direct select aspect ratios or move the menu cursor up in the OSD. When no
menu is present on-screen, the UP button toggles through aspect ratios in the
following order:
Anamorphic - Standard (4:3) - Letterbox - VirtualWide - Cinema - Virtualwide 2.35
Virtualwide 2.35 is available only on the VX-6000d/CineWide and
Note
only on the analog inputs (HD/RGB, SD Component, Composite
and S-Video). For more information about aspect ratios, refer to
Table 4-1.
6. LEFT BUTTON
Used to direct select inputs or move the menu cursor left in the OSD. When no menu
is present on-screen, the LEFT button toggles through the different sources, in this
order:
HDMI 2 - HDMI 1 - HD/RGB 2 - HD/RGB1 - Component SD - S-Video 2 - S-Video 1
- Composite
4 5 6
3 7
8 Runco VX-6000d Owner's Operating Manual
8 9
10