Sun Microsystems StorageTek 6140 Administration Manual page 27

Serial port
Expansion ports
2
Battery backup
compartment
FIGURE 1-3
TABLE 1-2
array controller tray.
TABLE 1-2
Ports/Switches
Host ports
(Ch1 - Ch4)
Ethernet ports
(1 and 2)
Expansion ports
(P1 and P2)
Serial port
Ethernet ports
2 1
Host ports
1 4 3 2
Controller A
(inverted)
Power supply
Sun StorageTek 6140 Array Controller Tray Ports and Switches (Back View)
describes the ports and switches on the back of the Sun StorageTek 6140
Sun StorageTek 6140 Array Controller Tray Ports and Switches (Back)
Description
Four 4-, 2-, or 1-Gbit/second FC Small Form-factor Plug-in (SFP)
ports. Ch4 host port is reserved for remote replication requirements.
RJ-45 Ethernet ports used for out-of-band management of the RAID
controller. An internal Ethernet device provides standard 10
Mbits/second and 100 Mbits/second full-duplex connectivity.
2-Gbit FC ports used to connect to the drive channel device and
expansion trays.
A port that allows terminal access to display or configuration of the
IP address for the tray, and for recovery of a lost password for the
tray.
Power supply
1
Controller B
1 2 3 4
Host ports
1 2
Ethernet ports
Chapter 1 Hardware Components Overview
Battery backup
compartment
1 2
Expansion ports
Serial port
11