Vx-33I Rear Panel - Runco VX-33I VX-33I Installation & Operation Manual

2.2

VX-33i Rear Panel

HD3 (VGA / Y-Pb-Pr)
Y-Pb-Pr) / (VGA HD3
HD2 (BNC)
(BNC) HD2
cover. lamp the off pull
to screw the Remove
Remove the screw to
pull off the lamp cover.
Figure 2-2. VX-33i Rear Panel
Figure 2-2 shows the VX-33i rear panel.
16
WIRED REMOTE
REMOTE WIRED
Service port.
Not for user
access
HD1 (RCA)
(RCA) HD1
1
1. LAMP COVER
Remove this cover to access the lamp compartment.
2. VACUUM FLUORESCENT DISPLAY (VFD)
Can be used instead of the OSD. Displays currently-selected menu or – if no menu is
selected – the current source, input resolution and aspect ratio.
If an error condition occurs, a message
appears here indicating the cause:
3. RUN LED
– Lights blue to indicate that the projector is functioning normally.
– Flashes blue (one second on/one second off) to indicate an error condition.
– Flashes blue (one half-second on/one half-second off) for approximately 90 seconds
after the system is turned off.
4. ISSUE LED
Lights red to indicate an error condition.
15 14
2 4 6 8
3 5 7
Please check issue(s)
Communication Error
6
13
SERVICE PORT
AUTHORIZED
PERSONNEL ONLY
L
L
10 12
9 11
Runco VX-33i Installation/Operation Manual