Radio Shack 2000655 User Manual

We hope you enjoy your AM/FM/Weather
Band Crank Radio from RadioShack. This radio
2000655
receives AM, FM, and all National Oceanic and
User's Guide
Atmospheric Administration (NOAA) Weather
Radio channels. Please read this user's guide
before using your radio.
AM/FM/Weather Band Package Contents
Crank Radio
• Crank Radio
• Rechargeable Battery Pack
• User's Guide
Specifications
AM .............................................................. 530 – 1710 kHz
FM ...................................................................88 – 108 MHz
Weather (WX) .................................162.4 – 162.55 MHz
Power Output (at 10% THD) ............................100 mW
Power .......................................................... 3.6V, 100mAh
.............. Ni-Mh rechargeable battery pack (included)
...................................... 3 AA batteries (not included) or
.....................5VDC Micro-USB adapter (not included)
Antenna ...........................................AM: built-in antenna
..........................................FM/WX: telescoping antenna
Speaker ......................................................... 3 in. (76 mm)
.............................................................. Impedance: 8 ohm
Specifications are subject to change and improvement
without notice. Actual product may vary from the images
found in this document.
2000655_UG_EN_071114.indd 1-7
BAND
• Select AM/FM/WX band.
• Enter/Exit time setting mode.
SCAN
Scan for stations.
POWER UP/DOWN
Tune stations.
ALERT
VOL+/VOL–
• Adjust the volume.
• Set the clock time.
ALERT
indicator
RECHARGE
indicator
Dynamo
crank
2 3
Use Dynamo Power
Power Your Radio
Your radio comes with a 3.6V, 300 mAh, Ni-
IMPORTANT! Always insert the rechargeable
MH rechargeable battery pack that can be
battery pack when you use your radio. Insert the
recharged using the dynamo crank.
battery pack plug into the connector, then place
the battery pack in the slot. 1. On the back panel of the radio, switch
DYNAMO/
BATTERY to
DYNAMO.
2. Lift the crank
DYNAMO/ and rotate it in
BATTERY either direction.
The RECHARGE
Indicator lights
when charging.
Charge time
depends on
cranking rate and
You can power your radio in three ways:
duration.
• Dynamo power using the included
For example, turning the crank at about
rechargeable battery pack
2 turns per second for about 90 seconds
• Three AA batteries (not included) should power the radio for about 10
minutes. If playback time decreases to less
• 5V DC Micro-USB adapter (not included)
than 5 minutes at this cranking rate, replace
the rechargeable battery pack.
4
Install Batteries (Optional)
Insert 3 AA
batteries (not
included) into
the battery
compartment
matching
the marked
polarity. Switch
DYNAMO/
BATTERY to
BATTERY.
Battery Notes:
• Dispose of batteries promptly and properly.
Do not burn or bury them.
• Use only fresh batteries of the required size
and type.
• Do not mix old and new batteries, different
types of batteries (alkaline or rechargeable),
or rechargeable batteries of different
capacities.
• If you do not plan to use the radio for a long
time, remove the batteries. Batteries can
leak chemicals that can damage electronic
parts.
5 6
Use a Micro USB Adapter (Optional)
You can listen to the radio and
charge the radio's battery pack at
the same time. Connect a 5V DC
Micro-USB adapter (not supplied)
to the DC IN jack. Using this
method, the battery pack requires
about 12 hours to fully charge.
DC IN
Notes:
• Your adapter must supply 5V DC and deliver
at least 500mA. Its plug must fit your radio's
5V jack. Using an adapter that does not meet
these specifications could damage your radio
or adapter.
• Batteries should NEVER be left unattended
while charging. Only adults should charge
the batteries. Use caution when using the
charger to avoid electric shock.
• Do not disassemble the charger or battery
pack. Incorrect assembly can result in risk of
electric shock or fire.
7
7/29/2014 4:19:21 PM