Amana SR520T Service page 95

Kit Instructions
Introduction
Important
• Mechanical experience is required to install trim kit.
• Depending on installer's knowledge and skill,
installation can take from one to three hours.
• Transfer food to an alternate cooling source. Check
refrigerator warranty certificate for specific
coverage. Warranty does not cover food loss.
• Ensure trim pieces adhere properly by confirming
surfaces are clean, dry and free of adhesive
residue.
• If unable to solve a problem during installation,
contact source from whom kit was purchased.
Decorator Panel Dimensions
Listed below are required height x width dimensions for
decorator panels. Panels are not supplied with this kit
and can be purchased locally.
To avoid personal injury or property damage,
refrigerator panels should not weigh more than 30
pounds (14 kilograms) and freezer panels should not
weigh more than 15 pounds (7 kilograms).
Without Dispenser
Refrigerator Door
Freezer Door
With Dispenser
Refrigerator Door
Upper Freezer Door
Lower Freezer Door
April 1998
Caution
63 3/32" x 19 3/8"
(1603 mm x 492 mm)
63 3/32" x 13 3/4"
(1603 mm x 349 mm)
63 3/32" x 19 3/8"
(1603 mm x 492 mm)
18 3/8" x 13 3/4"
(467 mm x 349 mm)
31 13/16" x 13 3/4"
(808 mm x 349 mm)
Procedure
To avoid personal injury or property damage, two
people should remove and rehang each door.
To avoid personal injury, protect hands and arms. Trim
pieces may have sharp edges.
Important
Save all screws and reuse in original location.
1. Remove top handle end caps by removing screws.
2. Dispenser Models
Remove crushed/cubed ice switch cover on
dispenser by pulling forward. Remove screws from
bottom of dispenser cover. Release bottom clips on
dispenser cover by placing taped edge of putty knife
underneath cover and pulling out. Release top clips
by holding bottom of dispenser cover out and slide
upward.
97
Caution
Caution
RS5290000 Rev. 0