Amana SR520T Service page 85

Kit Instructions
DS21S Kit - Non Dispenser Models
Install 1/4 inch (6 millimeter) freezer door top
retainer (Item #6) by placing trim at an angle on top
edge of panel. Align straight end of trim flush with
panel corner. Press trim onto panel. Install freezer
door side retainer (Item #17), freezer door bottom
retainer (Item #6) then freezer door side retainer
(Item #17) on panel. Notched end of trim must
overlap straight end of previously installed trim.
Confirm trim is secure. Remove nameplate by
placing putty knife covered with masking tape under
nameplate and pulling forward. Discard nameplate.
DS21S Kit - Dispenser Models
Install 1/4 inch (6 millimeter) upper and lower
freezer door top retainers (Item #6) by placing trim
at an angle on top edge of panel. Align straight end
of trim flush with panel corner. Press trim onto
panel. Install upper and lower freezer door right
side retainers (Items #12 or #14, respectively),
upper and lower freezer door bottom retainers (Item
#6) then upper and lower freezer door left side
retainers (Items #12 or #14, respectively) on panel.
Notched end of trim must overlap straight end of
previously installed trim. Confirm trim is secure.
April 1998
All Models
To prevent property damage, place masking tape on
back of panel at each corner. Tape prevents panel
from damaging doors.
1. Place masking tape on back of panels at each
corner.
2. Slide decorator door panels into place until panels
are secure. On DS19 and DS21 kits, handle side of
panel trim slides under handle trim. On DS20 and
DS20 kits, handle side of panel slides under handle
insert.
3. Install side door trim by peeling off 1 1/2 inches
(38 millimeters) of backing. Place trim against top
corner of refrigerator cabinet over edge of top trim.
After checking placement, peel off backing and
press into place. Place side door trim over edge of
bottom trim.
87
Caution
RS5290000 Rev. 0