Amana SR520T Service page 104

Kit Instructions
4. Slide bezel gusset from left frame into channel on
one end of top trim. Slide bezel gusset from right
frame into channel on other end of top trim. Confirm
trim is aligned properly at mitered corners. If mitered
corners do not fit properly, remove left and right
frames and make necessary adjustments.
5. Center top frame between top hinge covers. Confirm
front of trim is secure against front of refrigerator
cabinet.
6. Install top frame on refrigerator cabinet by removing
paper backing from velcro patches and pressing
tightly into place.
Important
Top frame may be removed. Remove top frame by gently
lifting top frame. Replace top frame by pressing tightly
into place. Side frames cannot be removed.
7. Align front edge of left and right frames along left
and right edges of refrigerator cabinet.
RS5290000 Rev. 0
8. Slide bezel gusset on left frame into top frame. Slide
bezel gusset on right frame into top frame. Confirm
trim is aligned properly and mitered corners are tight.
Important
Permanent, double-sided tape is used to attach some
pieces to refrigerator. Before removing paper backing,
check placement of pieces on refrigerator. Pieces may
be damaged if adjustment or removal is attempted after
installation.
9. Install left and right frames by peeling off 1
(38 millimeters) of backing. Press frames firmly on
refrigerator. After checking placement, peel off
backing and press into place.
10. Secure left and right frames to top frame by inserting
and tightening screws.
11. Roll refrigerator into opening and check for proper fit
with surrounding cabinets. Once proper fit is
achieved, roll refrigerator out of opening; plug in
power cord; and roll refrigerator back into opening.
106
1
/ "
2
April 1998