Amana SR520T Service page 78

Kit Instructions
Procedure
To avoid personal injury or property damage, two
people should remove and rehang each door.
To avoid personal injury or property damage,
temporarily tape doors shut.
Important
Save all screws and reuse in original location.
1. Tape doors shut using masking tape.
To avoid electrical shock which can cause severe
personal injury or death, green ground wire must
remain attached to hinge.
2. Remove top hinge covers by removing screws.
Trace around top hinges with a pencil. This helps
alignment when reassembling. On dispenser
models, unplug top hinge wire connectors. Remove
top hinge screws.
3. Remove tape from refrigerator door. Grasp
refrigerator door securely and lift up while opening.
This will free door from bottom hinge pin. Top hinge
may come off door.
4. Remove toe grille by pulling forward.
RS5290000 Rev. 0
Caution
Caution
WARNING
To avoid property damage, drain water from water tube
into small bucket.
5. Dispenser Models
Loosen water tube clamp screw. Loosen plastic
water tube union nut. Gently pull water tube away
from union nut and through tube clamp.
6. Remove tape from freezer door. Grasp freezer
door securely and lift up while opening. This will
free door from bottom hinge pin. On dispenser
models, plastic water tube must slide through slot
in bottom door hinge as door is raised.
7. Remove door stops by removing screws. Install
spacer and bottom trim by placing spacer and trim
on bottom of doors. Insert and tighten bottom trim
screws (Item #11). Replace door stops by placing
door stops on bottom of doors. Insert and tighten
screws.
8. Rehang doors by positioning bottom sockets onto
bottom door hinge pins. Position so doors are flush
with side of refrigerator cabinet. Handle side of
doors should be approximately 1/8 inch (3.2
millimeters) higher than hinge side of doors. Doors
will settle when loaded with food. On dispenser
models, when replacing freezer door, thread water
tube through hinge pin then water tube clamp.
80
Caution
April 1998