Yamaha Exciter T150 Owner's Manual page 52

PERIODIC MAINTENANCE AND ADJUSTMENT
4. Remove the spark plug as shown,
with the spark plug wrench includ-
ed in the owner's tool kit.
2
1. Spark plug wrench
2. Screwdriver
7
To check the spark plug
1. Check that the porcelain insulator
around the center electrode of the
spark plug is a medium-to-light
tan (the ideal color when the vehi-
cle is ridden normally).
TIP
If the spark plug shows a distinctly dif-
ferent color, the engine could be oper-
ating improperly. Do not attempt to
diagnose such problems yourself. In-
stead, have a Yamaha dealer check
the vehicle.
2. Check the spark plug for electrode
erosion and excessive carbon or
other deposits, and replace it if
necessary.
1
Specified spark plug:
NGK/CR8E
3. Measure the spark plug gap with a
wire thickness gauge and, if nec-
essary, adjust the gap to specifi-
cation.
1. Spark plug gap
Spark plug gap:
0.7–0.8 mm (0.031–0.031 in)
To install the spark plug
1. Clean the surface of the spark
2. Install the spark plug with the
TIP
If a torque wrench is not available
when installing a spark plug, a good
estimate of the correct torque is 1/4–
1/2 turn past finger tight. However, the
spark plug should be tightened to the
specified torque as soon as possible.
3. Install the spark plug cap.
4. Install the panel.
7-9
plug gasket and its mating sur-
face, and then wipe off any grime
from the spark plug threads.
spark plug wrench, and then tight-
en it to the specified torque.
Tightening torque:
Spark plug:
13 Nm (1.3 m·kgf, 9.4 ft·lbf)