TOHATSU VC85BS Quick Start Up Manual

5. STOPPING
1 3
Return the throttle Turn the main switch
dial to low speed to OFF position.
position.
スロットル
THROTTLE
始動 給水
START SUCTION
低 圧 低 圧
LOW HIGH
2 4
Close the discharge Close the fuel cock.
valve.
CLOSE
OPEN
5
Open the drain cocks.
Standard Type
After checking all the
Discharge Valve
water has been
drained from the
CLOSE OPEN
pump, close the cocks.
CLOSE
OPEN
Ball Cock Type
Discharge Valve (Option)
For pump casing
For muffler
6. PRECAUTIONS AFTER OPERATION
Maintenance after pumping seawater or foul water
After pumping seawater or foul water, flush fresh clean water
through the pump with the pump running to thoroughly clean
the inside.
And operate the vacuum pump for 5 seconds at low engine
speed in order to clean the vacuum pump.
7. Draining Fuel from the Carburetor
1
After stopping the
engine, close the fuel
cock.
2
Pull the knob of the
drain valve. (Fuel in the
3
MAIN
float chamber will flow
SWITCH
out.)
Drain valve
Knob
Open↔Close
The pot must
be emptied
each time.
Overheat
Overheat
switch
C
C
O
O
Countermeasuring when the monitor lamp is ON.
It is necessary to take a countermeasure if the lamp is on when turning the main
switch to the position of "Operation".
Monitor lamp
Level of fuel has
Fuel
dropped below one
third of tank capacity.
Oil level is below
Engine oil quarter of oil tank
capacity.
Engine stops caused
Overheat
by lack of cooling
water.
3
After all the fuel has
drained, release the
knob. (The drain valve
will return to the
closed position.)
4
Fuel from the drain pot
should be returned to
the fuel tank.
Dispose of fuel if contaminated
with water, dirt or other
substances.
Check the hose
is secured to the
drain pot.
Drain pot
8. USE OF OK MONITOR
Engine oil
Fuel
Main switch
Lamp ON Action required
Supply fuel.
Supply 2 stroke engine oil.
Check the cause and remedy it. Turn the
overheat sensor switch to "OFF" position
and start the engine. After confirming the
lamp is off, return the switch to "ON"
position. (VC82ASE/72AS/52AS)
Printed in Japan No.004-22015-0
VC85BS•VC82ASE•
VC72AS•VC52AS
Quick Start Guide
Be sure to read the instruction manual before operating
Tohatsu fire pump. Being familiar with all aspects of its
application will guarantee best performance.
1. BEFORE OPERATION
1
Battery initial charge
The battery mounted on the engine can be used immediately after filling
cells with electrolyte enclosed with battery (It is better to charge the
battery using the automatic battery charger after filling electrolyte). Do not
add distilled water because this is a sealed type battery. Please refer to the
INSTRUCTIONS on the battery.
2
Fuel & Engine oil
Fill gasoline (87 octane minimum at pump posted rating...91 based on the
research octane rating method) into the fuel tank. Fill two stroke engine oil
into the oil tank.
Gasoline Engine Oil
WARNING
Dry running of engine for over two minutes will cause seizure
of engine parts. Start suction of water immediately after
starting engine.