Steam Ironing; Dry Ironing; Auto Steam - Rowenta DX1900 Instructions Manual

Steam Ironing

WARNING !
• Never iron or steam clothes while they are being worn.
• Before ironing for the first time fill iron and allow to heat.
• The iron should be allowed to emit steam for 1 to 2 minutes
while pressing the burst of steam button a few times to
remove any impurities. This should also be done if iron is
not used regularly.
Steam is only produced when the temperature dial is set to the
shaded area (after •• setting).
Warning! Never iron clothes while theyare being worn.

Dry Ironing

- To iron without steam, slide the variabe steam control lever to
the position.
- We recommend dry ironing with an empty tank.
- Set the temperature for the type of material
to be ironed (•, •• or •••).
Steam ironing*

Auto Steam*

*
Depending on model
Burst of steam
- This feature is ideal for removing stubborn
wrinkles or pressing in sharp creases in hori-
zontal use. When the temperature control is
set to the steam zone (after ••) the burst of
steam can be used by pressing the burst of
steam button. Leave an interval of 4 seconds
between bursts.
Vertical Steam
- The iron can also be used vertically.
- This is especially useful for getting creases
out of hanging clothes, curtains, tapestries, etc.
- To steam vertically, press the burst of steam
button while holding iron in the upright position.
- You can steam iron by setting the tempe-
rature in the marked steam zone (after ••).
The steam quantity can be set to between
(no steam position) and
steam quantity). We recommend setting
to maximum steam quantity only when
the iron is set at temperature setting •••.
- For steam output to be automatically
adjusted to the soleplate temperature, turn
the steam control to the
(maximum
position.
AUTO